Borla

Designed to work with Borla(r) Cat-Back(tm) Systems ONLY. This Borla(r) SwitchFire(r) X-Pipe is designed to replace the Merge X-Pipe in Borla(r) Ca...

Transverse 'T' Flow design. Single 2.5" inlet on side of muffler body with dual 2.5" offset outlets, one on each end of the muffler body. The inter...

This X-Pipe with Mid-Pipes has been developed specifically for the Mustang GT. It is used to connect to Borla(r) Axle-Back systems creating a full ...

Gladiator owners can use this tip assembly to convert the Borla(r) High Clearance Climber / Rock Crawler system to a dual side exit system. This is...

Does NOT fit O.E. or other exhaust systems. Gladiator owners can use this tip assembly to convert the Borla(r) High Clearance Climber / Rock Crawle...

Borla(r) presents our high clearance Y-Pipe for the Toyota Tacoma 3.5L V6. Our Y-Pipe removes the Y-Pipe from under the transfer case and reroutes ...

Installation REQUIRES cutting the Original Equipment system. The Loop Delete Pipe provides more space underneath your Wrangler JL/ JLU or Gladiator...

For those of you who purchased a Borla(r) S-Type system, PN 140791 or 140791BC and want to step it up to the ATAK(r) sound, replace the front muffl...

If you have a Borla(r) ATAK(r) system, PN 140792, or 140792BC and want to turn down the volume a bit to the S-Type sound, replace the front muffler...

This 2" Mid-Pipe is used to connect the Borla(r) Axle-Back system PN 11961 to the factory catalytic converter creating a 2"diameter S-Type Cat-Back...

Replace the small muffler behind the primary muffler in the Borla(r) S-Type system with Polyphonic Harmonizer 60680 to attain the ATAK(r) sound lev...

Replace the Polyphonic Harmonizer behind the primary muffler in the Borla(r) ATAK(r) system with muffler 60679 to attain the S-Type sound level (qu...

Use this muffler/ resonator to change the sound of your Borla(r) Cat-Back(tm) 140755 from an S-Type sound level to an ATAK(r) sound level. Use ONLY...

Use this muffler/ resonator to change the sound of your Borla(r) Cat-Back(tm) system 140756 from an ATAK(r) sound level to an S-Type sound level. U...

This tip kit contains 2) tip assemblies with a total of 4) outlets. These single 3" Inside Diameter (I.D.) Inlet with dual 4" Outside Diameter (O.D...

This tip kit contains 2) tip assemblies with a total of 4) outlets. These single 3" Inside Diameter (I.D.) Inlet with dual 4" round Outside Diamete...

This resonator is designed to dampen the sound of our Cat-Back(tm) systems 140752, 140753 or 140758, or any of these with black tips. It is NOT des...